Industrial communication

External 4G LTE /5G antenna, SMA, vertical polarization

Quectel EM12-G LTE-A 4G Modem

• LTE Cat 12 module
• 42.0mm × 30.0mm × 2.3mm
• M.2 form factor
• Max. downlink 600Mbps / 150Mbps uplink
• Extended temperature range of -40°C to +85°C

WLAN antenni

• SMA liitin
• Pituus n. 19,5cm
• 2.4Ghz & 5.8Ghz
• Vertikaali polarisaatio

External 4G LTE & GPS & WIFI antenna

mPCIe to dual isolated CANbus 2.0B

• Compliant with PCI Express 1.1
• Meet the Requirements of the ISO 11898-1
• CAN bus 2.0B backward compatible with 2.0A
• Support baud rate 10/20/50/100/250/500/800/1000K
• Support CAN message acceptance filter
• Support Linux SocketCAN
• Compliant with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection
• Compliant with EN61000-4-2 (ESD) Air-15kV, Contact-8kV
• Termination resistor enabled/disabled by jumper
• 30μ” golden finger, 3-year warranty
• Industrial Temperature (-40°C to +85°C) suppor

mPCIe Single Port Gigabit SFP Ethernet Adapter (1x SFP)

• Single-port 1000MBASE-X controller with integrated MAC and PHY
• Four transmit quest and four receive queues per port
• 1000Mbps Fiber Ethernet networks transition

PCIe x4 Quad-port PoE+ Gigabit Vision Frame Grabber Card (Intel I210)

• Intel master chip scheme
• Mainly designed for industrial scene visual detection servers and equipment
• 30W PoE+ output, 4-Pin psu interface
• Adaptive to power output
• Large heatsink for heat dissipation

M.2 2242 to single isolated CAN bus Module

• Compliant with PCI Express 1.1
• Meet the Requirements of the ISO 11898-1
• CAN bus 2.0B backward compatible with 2.0A
• Support baud rate 10/20/50/100/250/500/800/1000K
• Support CAN message acceptance filter
• Support Linux SocketCAN
• Compliant with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection
• Compliant with EN61000-4-2 (ESD) Air-15kV, Contact-8kV
• Termination resistor enabled/disabled by switch
• Industrial Temperature (-40°C to +85°C) support

• Support CANopen high layer protocol
• Support baud rate 100/125/250/500(default)/800/1000K
• Support CAN message acceptance filter
• Keep configuration after hardware reboot
• Up to 6000 CAN messages per second (receive data)
• Support Listen-only mode
• Additional driver to support Linux SocketCAN
• Termination resistor enabled/disabled by jumper
• Complies with EN61000-4-5 2.5kV Surge protection
• Complies with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection
• Complies with EN61000-4-2 (ESD) Air-15kV, Contact-8kV
• Supports 3^rd mounting hole and USB Pin header for out-of minicard installation
• Supports -40 to +85 degrees

2.4G/5G Wi-Fi IoT Wireless I/O Module

• Wi-Fi Dual band 2.4/5 GHz up to 802.11 a/b/g/n/ac
• Support interchangeable I/O and Sensor module and easily configured with web UI
• MQTT, Modbus/TCP, SNMP, SNTP, TCP/IP, HTTP, HTTPS, UDP, and DHCP protocols supported
• Support smart roaming function
• Supports X.509 and up to WPA3 /TLS1.3
• UDP based AES-128 encrypted wireless P2P (Peer to Peer) function for multiple modules
• 10000+ data logger with SNTP/RTC time sync and WDT auto connection recovery

4DI/4Relay 2.4G WiFi IoT Wireless I/O

• WiFi 2.4 GHz IEEE 802.11b/g/n WLAN
• Supported protocols: Modbus/TCP, TCP/IP, UDP, DHCP, HTTP, MQTT
• Supports file-based cloud storage and local logging with RTC time stamp
• ŸSupports RESTful web API in JSON format for IoT integration
• Configured by mobile devices directly without installing software or App

• Provides 8 Fast Ethernet ports with Auto MDI/MDI-X
• Supports 10/100 Mbps Auto-Negotiation
• Provides compact size with DIN-rail/Wall mount, and IP30 metal mechanism
• Supports redundant 12 ~ 48 VDC power input and P-Fail relay
• Supports wide operating temperatures from -40 to 75°C

• Supports wide operating temperatures from -40 to 75 °C
• Supports redundant 12 ~ 48 VDC power terminal input plus one DC power jack and P-Fail relay
• Provides compact size with DIN-rail/Wall mount, and IP40 metal mechanism
• Supports 10/100 Mbps Auto-Negotiation
• Provides 5 Fast Ethernet ports with Auto MDI/MDI-X

Mini PoE+ Media Converter, 1000Mbps, SFP

• Supports IEEE802.3at PoE+ (25.5W) and IEEE802.3af PoE (15.4W) standards
• Serves as a power sourcing equipment (PSE) device
• Supports jumbo frame functionality (up to 10240 bytes)
• Supports multiple mounting options (desktop, DIN rail or wall-mount)
• Features in configurable PoE reset on fiber LOS
• Supports Link Fault Pass Through (LFPT)

Managed Hardened Media Converter, 1000Mbps, 2xSFP (also known as IE-Multiway 854-11121)

• Versatile 4-port media converter
• Supports SNMP for management
• Supports a variety of SFP modules
• Works under an extended temperature range
• Supports OAM, VLAN, 1+1 revertive
• Provides RS-232 CLI (command line interface) console port

M.2 2280 to four isolated CANbus 2.0B module

• Compliant with PCI Express 1.1
• Meet the Requirements of the ISO 11898-1
• CAN bus 2.0B backward compatible with 2.0A
• Support baud rate 10/20/50/100/250/500/800/1000K
• Support CAN message acceptance filter
• Support Linux SocketCAN
• Support SAE J1939/CANopen high layer protocol (Optional)
• Compliant with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection
• Compliant with EN61000-4-2 (ESD) Air-15kV, Contact-8kV
• Termination resistor enabled/disabled by switch
• 30μ” golden finger, 3-year warranty
• Industrial Temperature (-40°C to +85°C) support

M.2 2280 to dual isolated CAN bus Module

• Compliant with PCI Express 1.1
• Meet the Requirements of the ISO 11898-1
• CAN bus 2.0B backward compatible with 2.0A
• Support baud rate 10/20/50/100/250/500/800/1000K
• Support CAN message acceptance filter
• Support Linux SocketCAN
• Support SAE J1939/CANopen high layer protocol (Optional)
• Compliant with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection
• Compliant with EN61000-4-2 (ESD) Air-15kV, Contact-8kV
• Termination resistor enabled/disabled by switch
• 30μ” golden finger, 3-year warranty
• Industrial Temperature (-40°C to +85°C) support

Fiber to RS-232/422/485 Isolated converter, ST Multi-mode

• Wide range power input voltage.
• ST Multi-mode fiber port.
• Auto direction flow control on RS-485.
• Automatically switch signal RS-232, RS-422 and RS-485.
• Support 3000V DC isolation protection.
• All RS-422/485 signals provide surge and over current protection.
• Power/TX/RX mode LED indicator.
• Fiber transmission distance up to 2KM .
• Auto baud rate switching from 300bps to 115.2Kbps.
• Support Din-Rail and panel mount.

Fiber to RS232/422/485 Optical Isolated Converter, SC 40KM Single-mode

• Wide input range DC power supply.
• SC single mode fiber port.
• Auto direction flow control on RS-485.
• Auto RS-232/422/485 signals switching.
• Auto data format detecting.
• Auto baud rate switching from 300bps to 115.2Kbps.
• Support 3000V DC isolation protection.
• Support surge protection on RS-422/485 data lines.
• Power/TX/RX mode LED indicator.
• Fiber transmission distance up to 40KM .
• DIN rail or panel mount support. 

PCI Express Power over Ethernet card, 4-port 1000 Base(T), 802.3at/af compliant, low profile

• PCI Express® x1 compliant
• Support for total 90 watts under full load
• Support link aggregation/jumbo frames (9 Kbyte)
• Supports 12V~24V DC input power

PCI Express Power over ethernet card, 6-port 1000 Base(T), 802.3at/bt compliant

• Provide 6 x10/100/1000Base-T(X) PoE (P.S.E.) ports
• Total 180 Watts power budget with maximum 90 Watts per port
• PoE power sourced from 12~24VDC of ATX power
• Each LAN port supports both PoE and Non-PoE connections (Auto Detect & Classification)
• Supports SW/RDK (IEI GPOE Management Software Tools)
• Compatible with x4, x8 and x16 PCIe slots
• IEEE 802.3at/bt PoE compliant

8AI/5DI/4DO Intelligent I/O Gateway

• Linux Open Platform
• 8ch analog input(current or voltage)/5ch digital input/4ch digital output
• Program by linux C API, Node-RED (graphic programming environment)
• Cloud/Database access ,edge data analysis and logic control, data visulization by dashboard
• Interfaces: RS-485x2, Ethernet port x 2 ,1 x USB Type-A 2.0, 1 x USB Micro-B 2.0

4DI/4DO 2.4G WiFi IoT Wireless I/O

• WiFi 2.4GHz IEEE 802.11b/g/n WLAN
• Supported protocols: Modbus/TCP, TCP/IP, UDP, DHCP, HTTP, MQTT
• Supports file-based cloud storage and local logging with RTC time stamp
• Supports RESTful web API in JSON format for IoT integration
• Configured by mobile devices directly without installing software or App

8DI 2.4G WiFi IoT Wireless I/O with 1RS-485

• WiFi 2.4 GHz IEEE 802.11b/g/n WLAN
• Supported protocols: Modbus/TCP, TCP/IP, UDP, DHCP, HTTP, MQTT
• Supports file-based cloud storage and local logging with RTC time stamp
• Supports RESTful web API in JSON format for IoT integration
• Configured by mobile devices directly without installing any software or App