Industrial communication

WLAN antenni

• SMA liitin
• Pituus n. 19,5cm
• 2.4Ghz & 5.8Ghz
• Vertikaali polarisaatio

External 4G LTE & GPS & WIFI antenna

mPCIe Single Port Gigabit SFP Ethernet Adapter (1x SFP)

• Single-port 1000MBASE-X controller with integrated MAC and PHY
• Four transmit quest and four receive queues per port
• 1000Mbps Fiber Ethernet networks transition

PCIe x4 Quad-port PoE+ Gigabit Vision Frame Grabber Card (Intel I210)

• Intel master chip scheme
• Mainly designed for industrial scene visual detection servers and equipment
• 30W PoE+ output, 4-Pin psu interface
• Adaptive to power output
• Large heatsink for heat dissipation

M.2 2242 to single isolated CAN bus Module

• Compliant with PCI Express 1.1
• Meet the Requirements of the ISO 11898-1
• CAN bus 2.0B backward compatible with 2.0A
• Support baud rate 10/20/50/100/250/500/800/1000K
• Support CAN message acceptance filter
• Support Linux SocketCAN
• Compliant with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection
• Compliant with EN61000-4-2 (ESD) Air-15kV, Contact-8kV
• Termination resistor enabled/disabled by switch
• Industrial Temperature (-40°C to +85°C) support

• CANbus 2.0B backward compatible with 2.0A
• Support CANopen high layer protocol
• Support baud rate 100/125/250/500(default)/800/1000K
• Support CAN message acceptance filter
• Keep configuration after hardware reboot
• Up to 6000 CAN messages per second (receive data)
• Support Listen-only mode
• Additional driver to support Linux SocketCAN
• Termination resistor enabled/disabled by jumper
• Complies with EN61000-4-5 2.5kV Surge protection
• Complies with IEC 60950-1:2005 + A1: 2009 + A2:2013 2.5kV HiPOT protection
• Complies with EN61000-4-2 (ESD) Air-15kV, Contact-8kV
• Supports 3^rd mounting hole and USB Pin header for out-of minicard installation
• Supports -40 to +85 degrees

Fiber to RS-232/422/485 Isolated converter, ST Multi-mode

• Wide range power input voltage.
• ST Multi-mode fiber port.
• Auto direction flow control on RS-485.
• Automatically switch signal RS-232, RS-422 and RS-485.
• Support 3000V DC isolation protection.
• All RS-422/485 signals provide surge and over current protection.
• Power/TX/RX mode LED indicator.
• Fiber transmission distance up to 2KM .
• Auto baud rate switching from 300bps to 115.2Kbps.
• Support Din-Rail and panel mount.

Fiber to RS232/422/485 Optical Isolated Converter, SC 40KM Single-mode

• Wide input range DC power supply.
• SC single mode fiber port.
• Auto direction flow control on RS-485.
• Auto RS-232/422/485 signals switching.
• Auto data format detecting.
• Auto baud rate switching from 300bps to 115.2Kbps.
• Support 3000V DC isolation protection.
• Support surge protection on RS-422/485 data lines.
• Power/TX/RX mode LED indicator.
• Fiber transmission distance up to 40KM .
• DIN rail or panel mount support.